Cara Pasang Flasher Motor

>Hello Sohib EditorOnline, in this article we will discuss about the steps to install flasher motor. As we all know, flasher is an important component for motorcycles that helps to signal other drivers and pedestrians. Properly installing it will ensure your safety on the road. So, let’s get started!

Understanding Flasher Motor

Before we proceed with the installation process, let’s first have a brief understanding about flasher motor. Flasher motor is an electronic device that provides a flashing light signal, also known as turn signals or indicators. The flashing light indicates the direction you intend to turn while riding your motorcycle.

Flasher motor is made up of two components: a relay and a flasher unit. The relay is responsible for switching the power on and off to the turn signal bulbs, while the flasher unit controls the frequency of the flashing light.

Modern motorcycles come with an integrated flasher motor, but if your motorbike does not have one, you can purchase it from any motorcycle spare part dealer. Now, let’s discuss the steps to install flasher motor.

Step by Step Guide to Install Flasher Motor

Step 1: Turn Off Your Motorcycle

Before starting the installation process, make sure your motorcycle is turned off. This will ensure your safety and avoid any electrical shocks or damages.

Step 2: Locate the Flasher Motor

The next step is to locate the flasher motor on your motorcycle. Most motorcycles have the flasher motor located under the seat or near the fuse box. Refer to your motorcycle’s manual if you are unsure where it is located.

Step 3: Disconnect the Battery

Since we will be dealing with electrical components, it is important to disconnect the battery before proceeding. Locate the battery and disconnect the negative terminal to avoid any electrical shocks.

Step 4: Remove the Old Flasher Motor

If your motorcycle already has a flasher motor installed, you need to remove the old one first. Use a screwdriver to loosen the screws and carefully remove the flasher motor from its position.

Step 5: Install the New Flasher Motor

Now that the old flasher motor has been removed, you can proceed with installing the new one. Carefully place the new flasher motor in the same position and tighten the screws using a screwdriver.

Step 6: Connect the Wires

The next step is to connect the wires to the new flasher motor. Take note of the wire colors and connect them accordingly. In most cases, the black wire is connected to the negative terminal while the other wires are connected to the positive terminal.

Step 7: Test the Flasher Motor

Once the wires are connected, it’s time to test the flasher motor. Reconnect the battery and turn on the motorcycle. Test the turn signals by switching them on and off. Make sure both the left and right turn signals are working properly.

Frequently Asked Questions (FAQ)

Conclusion

Congratulations, you have successfully learned how to install a flasher motor on your motorcycle. Remember to always prioritize your safety on the road and maintain your motorcycle regularly for a smooth and safe ride.

Cara Pasang Flasher Motor